The MDO-2000E series is a multifunctional mixed domain oscilloscope
The MDO-2000E series is a multifunctional mixed domain oscilloscope. This series includes four models: MDO-2000EG, MDO-2000EX, MDO-2000EC, and MDO-2000ES.
The MDO-2000EG has a built-in spectrum analyzer and a dual channel 25MHz arbitrary wave generator; The MDO-2000EX has a built-in spectrum analyzer, a dual channel 25MHz arbitrary wave generator, a 5000 bit digital multimeter, and a dual channel 5V/1A power supply; MDO-2000EC has a built-in logic analyzer, spectrum analyzer, and dual channel 25MHz arbitrary wave generator; MDO-2000ES has a built-in logic analyzer, spectrum analyzer, dual channel 25MHz arbitrary wave generator, 5000 bit digital multimeter, and dual channel 5V/1A power supply "six in one" model full function oscilloscope
When operating the MDO-2000E spectrum analyzer, users can input the center frequency, sweep width, start frequency, and stop frequency according to test requirements, thereby quickly and intuitively observing the required frequency range, enabling users to experience the user interface of the direct real spectrum analyzer. When observing frequency domain displays, engineers can observe waveform characteristics that are not easily visible from time domain waveforms, such as the harmonic components of the waveform and the frequency characteristics of the modulated signal.
The FFT of a conventional oscilloscope always calculates the entire signal bandwidth as half the sampling rate (Fs). However, due to insufficient computing power, more points cannot be used for FFT calculations. Due to insufficient frequency resolution of the calculated results, users cannot obtain detailed frequency information of the signal. MDO-2000E analyzes the signal spectrum of interest. Compared to the FFT of an oscilloscope, engineers using the MDO-2000E series can effectively measure signals in the frequency domain.
The MDO-2000E spectrum analyzer also includes spectrum trajectory settings (normal, maximum hold, minimum baud, and average). Users can freely select various spectrum trajectories to display simultaneously. "The detection method (Sample,+Peak, - Peak, and Average) can be set separately for each track. In addition, users can manually mark the corresponding position through the cursor to reflect the frequency and amplitude. The search function can also be applied to the peak table of the spectrum.". The amplitude is displayed in dB, and the measurement data can be obtained by marking.
MDO-2000E Series Mixed-domain Oscilloscopes Features :
- 200/100/70MHz bandwidth selections ; 2 or 4 channels
|
- Real time sampling rate for each channel is 1GSa/s (2 channel models)
|
- Maximum real time sampling rate is 1GSa/s (4 channel models)
|
- Per Channel 10M memory depth and VPO waveform display technology
|
- Waveform update rate up to 120,000 wfms/s
|
- 8 " WVGA TFT LCD display
- Free Frequency Response Analyzer Software
|
- Maximum 1M FFT provides higher frequency domain resolution measurements
|
- High ,low and band pass filter functions
|
- 29,000 segmented memories and waveform search functions
|
- I2C/SPI/UART/CAN/LIN serial bus trigger and decoding function
|
- Data log function is able to track signal changes up to 1000 hours
- Network storage function
- Mask test function
|
- MDO-2000EG equips with a spectrum analyzer and a dual channel 25MHz AWG MDO-2000EX equips with a spectrum analyzer ; a dual channel 25MHz AWG; DMM and power supply
- True RMS measurement in DMM function
|
){kind=link}
){kind=link}